Camera Titles Set Up - JVC SW-D8000U Instruction Manual

Hide thumbs

Table Of Contents

Table of Contents

SW-D8000U, 16CH. COLOR VIDEO MULTIPLEXER

NOTE: The sensitivity setting can affect the degree of detection within each zone, and must be

adjusted together with the target size for best performance.

Link to Alarm:

(This setup is only used for INTRUSION detection.) The SW-D8000U's motion detection for each

camera can be used as a sensor to activate any of the alarm inputs. The SW-D8000U allows the

programmer to link the internal motion detection directly to the unit's rear panel alarm to create a

motion based alarm sensor input. No physical wiring is needed to link to an alarm input, just the

menu entry.

If an SW-D8000U alarm input is activated by one of the SW-D8000U's internal motion detector

channels, the unit will react in exactly the same way as for any other external sensor activating that

alarm input. The system does not differentiate between an input from another alarm sensor and the

input activated by the link from the internal motion detection.

Because the SW-D8000U's internal motion detection can be set up to be more effective than simple

activity detection, it can be used to replace a separate external motion detector and hence will save

the user that cost in most installations. Detection of intruders is normally only set up in areas where

there is little or no expected movement. In high traffic areas, intrusion detection is not a feasible

application of motion detection.

NOTE: Some outdoor environments can have very complex intrusion detection requirements. In

those cases, it is preferable to use a motion detector intended specifically for complex

outdoor situations.

Linking INTRUSION to Alarms:

Select the Alarm number which is to be activated (1-10/16) in the sub-menu.

Remember that if motion is linked to alarms then, because the alarm input record list always takes

priority over the activity record list, the alarm record list will be used. The activity record list will be

ignored while an alarm is active, even if that alarm results from motion linked to an alarm input.

Linking INTRUSION to Macro functions:

Intrusion detection can be linked indirectly to a macro, by linking an alarm input which has been set

to start macros. (See LINK TO MACROS sub-menu in ALARMS section)

4.12