Table of Contents
Advertisement
3
Calibrating the Sensor
No Parts Required
Procedure
1.
While the machine is on a flat surface, remove
the plug from calibration connectors (labeled
P05 and P06).
2.
Plug the connectors together.
3.
Turn the ignition key to the O
not start the engine.
Note:
The LED light blinks as the sensor
calibrates.
4.
When the light no longer blinks, turn the ignition
key to the O
position.
FF
5.
Disconnect the calibration connectors and install
the plug onto the connectors.
Operation
Using the Slope Sensor
When you start the machine, the LED light illuminates
for 5 seconds to indicate that the sensor is functioning
properly.
The light and alarm indicates the severity of the slope:
•
No light—normal operating conditions
•
Slow, flashing light—moderate slope
•
Fast, flashing light and audible alarm—steep
slope; proceed to a more shallow slope.
WARNING
Slopes are a major factor related to
loss-of-control and tip-over accidents, which
can result in severe injury or death.
Use extreme caution when operating the
machine on a slope.
position, but do
N
8
Advertisement
Table of Contents
