Toro 02945 Installation Instructions Manual page 3

Figure 3
1. Bolt (M10)
2. Slope sensor mount
4. Install the wire harness connector labeled P02
to the slope sensor
Figure 4
1. Coil the wire harness in
this location.
2. Wire harness
5. Route the wire harness towards the control
panel (Figure 4) and ensure that it is secured
and away from moving parts or pinch points.
6. Coil any additional amount of wire harness to
the left of the control panel
7. Remove the plug and install the LED light in the
control panel as shown in
3. Flange nut (M10)
(Figure 4).
3. Wire harness connector
(P02)
(Figure 4).
Figure 5.
g305020
1. LED light
8. Connect the remaining wire-harness connectors
as follows:
•
Wire harness connector labeled P01:
Connect to one of the 6-pin sealed
connectors located on the main harness
below the control panel.
•
Wire harness connector labeled P08:
Connect to the LED light.
•
Wire harness connector labeled P09:
Connect to the alarm and position the alarm
under the control panel.
Note:
obstruct any controls.
9. Secure the operator's platform; refer to your
machine Operator's Manual.
g307124
10. Install the slope-sensor decal adjacent to
the machine-stability decal on the operator's
platform (Figure
3
Figure 5
Ensure that the alarm does not
6).
g307377