Table of Contents
Advertisement
Quick Links
Slope Sensor Kit
LT3340 Triple Reel Mower or LT-F3000 Triple Flail Mower
Model No. 02951
Note:
This kit is for Stage 5 machines only.
Safety
Safety and Instructional
Decals
Safety decals and instructions are
easily visible to the operator and are
located near any area of potential
danger. Replace any decal that is
damaged or missing.
140-2710
1. Warning—read the Operator's Manual; a fast flashing light
and alarm sounding indicates a steep slope; a slow flashing
light indicates a moderate slope; no light indicates normal
operating conditions.
© 2021—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
decal140-2710
Register at www.Toro.com.
Form No. 3440-871 Rev A
Installation Instructions
*3440-871*
Original Instructions (EN)
Printed in the USA
All Rights Reserved
Advertisement
Table of Contents
Related Manuals for Toro 02951
Summary of Contents for Toro 02951
- Page 1 Form No. 3440-871 Rev A Slope Sensor Kit LT3340 Triple Reel Mower or LT-F3000 Triple Flail Mower Model No. 02951 Installation Instructions Note: This kit is for Stage 5 machines only. Safety Safety and Instructional Decals Safety decals and instructions are...
-
Page 2: Installation
Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Prepare the machine. Slope sensor Carriage bolt (1/4 x 2 inches) Lock nut (1/4 inch) Install the kit. Spacer Slope sensor decal Fuse (2 A) - Page 3 g308336 Figure 2 1. Machine-stability decal 2. Slope-sensor decal g338090 Figure 1 1. Carriage bolt (1/4 x 2 4. Slope snsor inches) 2. Machine frame 5. Lock nut (1/4 inch) 3. Spacer Locate the slope sensor connector in the main wire harness and plug it into the slope sensor.
-
Page 4: Installing The Fuse
Installing the Fuse Parts needed for this procedure: Fuse (2 A) Procedure Open the lid on the left pod. Remove the 3 knobs inside the storage pod (Figure g338477 Figure 4 1. Install the fuse in this 2. Fuse block location Install the fuse-block cover and install the storage pod with the 3 knobs. - Page 5 g317524 Figure 6 1. LED light When the InfoCenter shows Message 601, Slope Sensor Calibrated, Cycle keyswitch, and the light no longer blinks, turn the ignition key to the O position. Disconnect the calibration connectors and install the plug onto the connectors. g350905 Figure 5 1.
-
Page 6: Operation
Operation Using the Slope Sensor The light and alarm indicates the severity of the slope: • Red light—normal operating conditions • Slow, flashing red light and Advisory B2713 displaying on the screen—moderate slope g317557 Figure 8 Advisory B2713 • Fast, flashing red light, audible alarm, and Advisory B2714 displaying on the screen—steep slope;... - Page 7 Notes:...