Table of Contents
Advertisement
1. Bolt (M6 x 35 mm)
2. Slope sensor mount
13.
Connect the wire-harness connector labeled
P02 to the slope sensor.
14.
Use 2 bolts (M6 x 25 mm) and 2 flange nuts
(M6) to secure the slope sensor mount to the
electrical panel
(Figure
1. Slope sensor mount
2. Flange nut (M6)
15.
Connect the kit-wire-harness connector labeled
P01 to one of the 6-pin sealed connectors
located below the relays on the electrical panel.
16.
Use cable ties to secure the wire harness away
from moving parts or pinch points.
Figure 9
3. Slope sensor
4. Flange nut (M6)
10).
Figure 10
3. Bolt (M6 x 25 mm)
17.
Install the slope-sensor decal adjacent to the
machine-stability decal on the storage-pod lid
(Figure
11).
g304544
1. Machine-stability decal
Installing the Kit
PLH800 Machines
1.
Remove the battery cover; refer to the electrical
system maintenance section of your Operator's
Manual.
2.
Use 2 bolts (M6 x 35 mm) and 2 flange nuts
(M6) to secure the slope sensor on the mounting
plate in front of the battery
g304543
1. Battery
5
Figure 11
2. Slope-sensor decal
(Figure
12).
Figure 12
2. Slope sensor
g308336
g307264
Advertisement
Table of Contents
