Sharp AR-FX7 Service Manual page 72

C. Automatic reduction of faxed document
If the width of the faxed document is greater than the receiving
machine's maximum receivable width, the document will be automati-
cally reduced.
Faxed Receiving
document machine's
width paper width
11" x 17" 8-1/2" x 14"
11" x 17" 8-1/2" x 11"
8-1/2" x 14" 8-1/2" x 11"
A document can also be faxed without reducing its size. In this case,
the left and right edges will not be transmitted.
4. Own number sending
This function prints the date, time, your programmed senderís name,
your programmed sender's fax number, and the page number at the
top center of each page that you fax.
Example of fax page printed out by the receiving machine
MAY-11-200X-FRI 03:00 PM SHARP PLANNING DIV.
↑ ↑
1) 2)
1) Date and time: programmed in the custom settings.
2) Sender's name: programmed in the key operator programs.
3) Sender's fax number: programmed in the key operator programs.
4) Page number: 3-digit number appearing in the format, "page num-
ber/total pages" (only the page number appears if you use manual
transmission or Quick On-Line transmission). If desired, you can
use a key operator program to have the page number omitted.
A. Position of sender's information
You can select whether the sender's information is added outside the
printed fax image or inside the image in the key operator programs.
The initial factory setting is outside the image.
Outside scanned data
Direction of transmission
None of the transmitted image is cut off; however, the transmitted
image is longer than the scanned image, and thus when both the
sender and the receiver use the same size of paper, the printed fax
may either be reduced or split up and printed on two pages.
Inside scanned data
Direction of transmission
Reduced size Ratio
8-1/2" x 14" 1 : 0.70
(Area ratio)
8-1/2" x 11"R 1 : 0.5
(Area ratio)
8-1/2" x 11"R 1 : 0.64
(Area ratio)
FAX No.0666211221 P.001/001
↑ ↑
3) 4)
AR-FX7 KEY OPERATOR PROGRAM 8 - 4
The top edge of the scanned image will be cut off by the sender's infor-
mation; however, when both the sender and the receiver use the same
size of paper, the printed fax will neither be reduced nor split up and
printed on two pages.
5. Quick On-line
When the RSPF is used for memory transmission and there are no
previously stored jobs waiting or in progress (and the line is not being
used), the machine dials the destination and begins transmitting
scanned pages while the remaining pages are scanned. This transmis-
sion method is called Quick On-line. The messages "SCANNING
ORIGINAL." and "CONNECTING." both appear until scanning of the
final page is completed.
If the receiving party is busy when a Quick On-line transmission is
attempted, the transmission will be automatically reattempted at a later
time.
NOTE:
• The machine is initially set (factory setting) to perform Quick On-line
transmission. If desired, you can turn off this function in the key
operator programs.
• When an original is transmitted using the following methods, the job
will be stored in memory (Quick On-line transmission will not be per-
formed):
1) Sending from the document glass
2) Broadcast transmission
3) Timer transmission
4) F-code transmission