National Instruments SCXI-1000 Quick Start Manual page 5

1 PXI DAQ Module
SCXI Chassis
1. Touch any metal part of the chassis to discharge static electricity.
2. Insert the module into the SCXI slot.
3. Secure the module to the chassis front panel mounting rail using the two thumbscrews.
1 Thumbscrews
SCXI USB Modules
SCXI USB modules are plug-and-play, integrated signal conditioning modules that communicate
between an SCXI system and a USB-compatible computer or USB hub, so no intermediate DAQ device
is needed. SCXI USB modules, such as the SCXI-1600, cannot be used in a PXI/SCXI combination
chassis or in multichassis systems. After you install the module in the chassis, complete the following
steps:
1. Connect the USB cable from the computer port or from any other USB hub to the USB port on the
SCXI USB module.
2. Attach the cable to the strain relief using a cable tie.
© National Instruments Corporation
1
2
2 Injector/Ejector Handle
Figure 5. Installing the PXI Module in a New Chassis
®
1
5
4
3
2
1
2
1
Figure 6. Installing the SCXI Module in a New Chassis
5
3
3 Injector/Ejector Rail
2 Module
SCXI Quick Start Guide