Setting⑮ : Overlap Output - Mitsubishi Electric KD Series User Manual

Address Register name
7120 OverlapEnable
5-2-16 Overwrap output
This function enables to add first 144 pixels data (6.1mm width of image )
of a next module on the output of a module.
KD-CXL CIS
Signal
processing
board
12,096pixels(L4)
13,824pixels(L5/L6)
+ 144pixels
× RGB
TM－XJ101C
5-2 Setting⑮: Overwrap output
R/W Val
R/W 0 or 1
Sensor array
Pixel data
12,960pixels(L4/L6)
15,552pixels(L5)
+ 144pixels
× RGB
Set Overwrap output On/Off
0:OFF /1:ON
[Function]
This product have 2 or 3 channels of
CoaXpress® and output parallel image data.
This product can output image data from 2
or 3 different channels, which the image
data are overwrapped partially. This
function contribute to acquire the image
data between the multi channels of
CoaXpress® .
The number of the added or overwrapped
pixels depend of the output resolution. (The
total overwrapped image data correspond
to the 6.1mm width of the acquired image.)
12,960pixels(L6)
× RGB
CoaXPress® is a trade mark registered by JIIA (Japan Industrial Imaging Association).
Result
Number of the added pixels :
144 pixels @600dpi
72 pixels @300dpi
48 pixels @200dpi
36 pixels @150dpi
© Mitsubishi Electric Corporation
Initial
0
79