Mitsubishi Electric KD Series User Manual page 42

【Remark】 How to install CIS into your equipment
①Attach CIS to your system at both end sides of CIS by M4 screws.
Focal point is defined the position from the datum holes at the end of CIS.
There is the focal point of CIS at 62.5mm from the datum holes.
②There are 4screw holes(M4) each end side of CIS (total 8 screw holes).
Use datum holes (φ3 hole and 3x4slot ) to make sure the CIS is on the
right position.
③Please fasten between CIS and your equipment by M4 screws with 4 internal
threads in front of CIS.
Use 2 datum holes (3x4slot or 3x5slot) to make sure the CIS is on the
right position.
Furthermore, when the CIS is installed to your equipment, to absorb
small deformation of CIS(for example, the bend of aluminum parts of CIS),
please make the through holes to fix between CIS and your equipment
in the bracket prepared by customer as slot. (Detail is shown in next page.)
④To install CIS in your system, please use all of fastening points (12points).
Recommended fastening torque is shown in below table.
Material of screw
Iron (strength ranking 4.6)
Stainless (SUS 304)
Brass (C3601BD)
⑤A frame of CIS is made of aluminum. When fasten a screw, be careful
about thread damage of screw hole.
⑥Pin length for adjusting position of CIS is 5.0mm or less.
⑦Maxium product length of this product is 1.7m. When this product is
carried or installed into your system, please be careful surrounding you
and this product. And please do not hit anything.
TM－XJ101C
3-1 Installation
Fastening torque [N・cm]
165 ± 16
144 ± 14
96 ± 9
3-1-7 Both Side of CIS
Bracket prepared
by customer
3-1-8 The view of fixing construction in front of CIS from side
Detail B(Cross section)
Pin Length
5.0mm max.
Pin Length
5.0mm max.
Bracket prepared by
customer
© Mitsubishi Electric Corporation
Bracket prepared by
customer
42