Operation; Starting The Trimmer; Stopping The Trimmer; Charging The Battery Pack - Toro 51484 Operator's Manual

Operation

Important:
The battery pack is not fully charged
when it is purchased. Before using the trimmer for
the first time, place the battery pack in the charger
and charge until the LED indicators turn green.
Make sure to read all safety precautions. With
regular use, it will need shorter charging time. If
storing for a prolonged period of time, remove the
battery pack. When ready to use again, charge the
battery pack until the LED indicators turn green.

Starting the Trimmer

1. Align the tongue of the battery pack with the
cavity in the handle housing
1. Trigger handle
2. Tongue
2. Grasp the trigger handle
3. Push the battery pack into the handle until the
latch locks into place.
4. To start the trimmer, slide the lock switch back,
then squeeze the trigger
(Figure 6).
Figure 6
3. Latch
(Figure 6).
(Figure 7).
1. Lock switch

Stopping the Trimmer

To stop the trimmer, release the trigger.

Charging the Battery Pack

Important:
For best results, charge your battery
tool where the temperature is more than 4°C (39°F)
g016190
but less than 40°C (104°F). To reduce the risk of
serious personal injury, do not store it outside or
in vehicles. Charging time will increase if you do
not charge it within this range.
Appropriate Temperature Ranges
Charge/store the battery pack
at
Use the battery pack at
Use the trimmer at
Store the trimmer at
*Charging time will increase if you do not charge the
battery within this range.
Store the tool, battery pack, and battery charger in an
enclosed clean, dry area.
1. Turn the battery pack upside down and line up
the battery terminal with the slot in the charger
(Figure 8
10
Figure 7
2. Trigger
4°C (39°F) to 40°C (104°F)*
0°C (32°F) to 49°C (120°F)
0°C (32°F) to 49°C (120°F)
0°C (32°F) to 45°C (113°F)*
and Figure 9).
g016189