Preparing The Battery Pack For Recycling - Toro 51484 Operator's Manual

1. Spool
Note:
Remove any old string remaining on the
spool.
3. The spool accepts up to 4.5 m (15 ft) of
string.Use only 1.65 mm (0.065 inch) diameter
monofilament string.
Note:
Do not use any other gauge or type of
string, as this could damage the trimmer.
4. Insert the string into the anchor hole in the upper
part of the spool
onto the spool in the direction shown by the
arrows on the spool.
5. Place the string in the slot on the upper spool
flange, leaving about 152 mm 6 inch (6 inches)
extended beyond the slot.
Note:
Do not overfill. After winding the string,
there should be at least 6 mm 1/4 inch (1/4 inch)
between the wound string and the outside edge
of the spool.
6. Replace the spool and the spool retainer. Refer
to Replacing the Spool (page 13)
manual.
Service
Should this item need service, take the product to
your Authorized Service Dealer.
Preparing the Battery Pack
for Recycling
Important:
Upon removal, cover the terminals of
the battery pack with heavy-duty adhesive tape.
Do not attempt to destroy or disassemble the
Figure 14
2. Hole
(Figure 14). Wind the string
earlier in this
battery pack or remove any of its components.
Recycle or properly dispose of lithium-ion battery
packs at a battery recycling facility.
g015662
14
For more information on recycling lithium-ion
battery packs and to locate the battery
recycling facility closest to you, visit
www.Call2Recycle.org (US and Canada only).
If you are located outside of the US and
Canada, please contact your authorized Toro
distributor.