Sip System Information Setup - NEC SL2100 Programming Manual

SL2100
Level:
SA
Description
Use Program 10-28 : SIP System Information Setup to set up basic SIP trunking.
Program
10 Input Data
Item
No.
01 Domain Name
02 Host Name
03 Transport Protocol
05 Domain Assignment
06 IP Trunk Port Binding
Conditions
None
Feature Cross Reference
None
2-32
Program 10 : System Configuration Setup
Profile
Item Input Data
Up to 64 Characters
(ex. : UserID@Host-
Name.DomainName)
Up to 48 Characters
(ex. : UserID@Host-
Name.DomainName)
0 = UDP
1 = TCP
2 = TLS (V2.0 or higher)
0 = IP Address
1 = Domain Name
0 = Disable
1 = Enable

10-28 : SIP System Information Setup

Description
Set the domain name of the SIP-URL.
Set the host name of the SIP-URL.
Set the protocol for the connection.
If the information from Telco was a domain
name (siptrunk@sip.com) then set to do-
main. If the information for Telco was a IP
address then set to IP Address.
Trunk port binding is only used for SIP
trunks to the provider in Non-Registration
Mode only. When this is disabled, an in-
bound call comes in and follows your DID
routing but it comes in on the first available
trunk. When enabled, the inbound call
comes in and follows your normal DID
routing but maps to that specified trunk. If
that trunk is busy, it sends back a busy un-
less you build a hunt group. To build the
hunt group, it references command
14-12-02 (pilot register ID). This then
points you to command 10-36-02. All the
numbers with the same pilot are in the
same hunt group.
Program 10 : System Configuration Setup
ISSUE 2.0
1 ~ 6
Default
No Setting
No Setting
0
0
0