Copper Gigabit Ethernet Connectors And Cables; Figure 14 Two-Port Copper Gigabit Ethernet Nic - Nokia EM7500 Installation Manual

5
Connecting PMC Network Interface Cards
Packet tracing for analysis through tcpdump
Compliance with IEEE 802.3ab Gigabit Ethernet specification
Figure 14
Ethernet NIC you use in the Nokia IP390 appliance.

Figure 14 Two-Port Copper Gigabit Ethernet NIC

Copper Gigabit Ethernet Connectors and Cables

The copper Gigabit Ethernet NIC receptacles use RJ-45 connectors.
To connect to a 1 Gbps hub, switch, or router, use a straight-through RJ-45
cable (Cat 5 type cable, or as required by your network configuration).
Note
All Nokia copper Gigabit Ethernet NICs support cable auto-sensing. You
can use a straight-through or crossover cable to connect the NIC to a
Gigabit Ethernet hub or switch, or to connect directly to a host.
In Figure
with the copper pins facing up and toward you.
66
All manuals and user guides at all-guides.com
shows the front panel details for the two-port copper Gigabit
Link LED (solid yellow for 10/100 Mbps, solid green for 1000 Mbps)
Activity LEDs (blinking yellow)
LINK
ACT
RJ-45 connectors
15, the RJ-45 cable output connector is numbered from right to left,
LINK
ACT
00386.5
IP390, 105i & 105s Security Platform Installation Guide