Before You Start - Nokia EM7500 Installation Manual

All manuals and user guides at all-guides.com

Before You Start

To remove, install, or replace a Nokia NIC, you need the following:
A Phillips-head screwdriver
Physical access to the appliance
Access to the appliance by using Nokia Network Voyager or the CLI
Suitable, grounded work surface
Network interface card kit
To remove, install, or replace a NIC
Note
Because power to the appliance is automatically disconnected
when the chassis tray assembly is opened, you do not need to
manually disconnect the power for this procedure. Any servicing of
the unit, however, should be completed with the chassis tray
assembly fully removed from the appliance. Power is still active in the
chassis body and care should be taken when working on the power
supply or power supply wiring without disconnecting the power cord.
1. Use Network Voyager or the CLI to halt the appliance.
To use Network Voyager to shut the appliance down, select
System > Configuration > Reboot or Shutdown > Halt.
To use the CLI to shut the appliance down, enter halt at the prompt.
IP390, 105i & 105s Security Platform Installation Guide
Removing, Installing, and Replacing NICs
53