Nokia EM7500 Installation Manual page 39

All manuals and user guides at all-guides.com
Note
All Nokia copper Gigabit Ethernet NICs support cable auto-sensing.
You can use a straight-through or crossover cable to connect the NIC
to a Gigabit Ethernet hub or switch, or to connect directly to a host.
For details, see
To connect fiber-optic Gigabit Ethernet devices
Use a multimode, fiber-optic cable with an LC connector to connect to a
10-Mbps, 100-Mbps, or 1000-Mbps hub or directly to a host. The
destination end of the cable can be either LC or SC, depending on the type
of connector required for the destination Gigabit Ethernet device. You can
also use a half-duplex LC-to-LC cable to loop back the transmit port of an
interface to the receiver port.
For details, see
page 69.
After you connect the network interfaces, continue with
"Performing the Initial Configuration."
IP390, 105i & 105s Security Platform Installation Guide
"Copper Gigabit Ethernet Connectors and Cables"
"Fiber-Optic Gigabit Ethernet Connectors and Cables"
Connecting to Network Interfaces
on page 66.
Chapter 3,
on
39