GE DigitalFlow DF868 Programming Manual page 95

Creating a Standard Log
(cont.)
Logging Data
Table 3-1: Measurement Parameter Options
Option Bar Choice
=
[F1] VEL
=
[F2] VOLUM
=
[F3] +TOTL
=
[F4] -TOTL
→]
=
[ + [F1] MDOT*
→]
=
[ + [F2] +MASS*
→]
=
[ + [F3] -MASS*
→]
= POWER**
[ + [F4]
→] →]
=
[ + [ + [F1] +ENRG**
→] →]
=
[ + [ + [F2] -ENRG**
→] →]
=
[ + [ + [F3]
* Available only if "Mass Flow (static)?" = YES
** Available only if "Energy Option?" = YES
Refer to Chapter 3, Diagnostics, of the Service Manual for a
discussion of the many parameters accessible via the
Note: The units assigned to the parameters in Table 3-1 above are
those selected in the
6. Use the [←], [→] and
to be logged. See Table 3-1 above for a list of the available
options.
7. Use the [←], [→] and
be logged. See Table 3-1 above for a list of the available options.
•
If you selected a totalized value for display, go to step 8.
•
If you did not, go to step 9.
8. At the Set LOG Totals to 0? prompt, press
totals at their present value or press
zero.
Note: The
Set LOG Totals to 0?
-TOTL
was selected as one of the three parameters to log.
YES
Choosing at this prompt only resets the log totals to zero
and has no effect on the meter totals.
Description
Flow Velocity
Volumetric Flow
Forward Totalized Volume Flow
Reverse Totalized Volume Flow
Mass Flow
Forward Totalized Mass Flow
Reverse Totalized Mass Flow
Energy Flow Power
Forward Energy Flow
Reverse Energy Flow
Diagnostic
DIAG
User Program SYSTM
(
[F1]-[F4]
keys to select the second parameter
[F1]-[F4]
keys to select the third parameter to
[F1]
[F2]
to reset the log totals to
prompt only appears if either
March 2008
DIAG
option.
submenu).
to leave the log
+TOTL
or
3-3