Log Type; Starttime Prompt; Start Date Prompt - GE DigitalFlow DF868 Programming Manual

Log Type

STARTTIME Prompt

START DATE Prompt

Logging Data
[F1]
9. Press to create a non-circular log or press
circular log.
A non-circular log automatically stops when the meter runs out of
memory or the specified
continuously until manually stopped, but only the data from the most
recent log cycle is saved. At the start of each cycle, the oldest
recorded data is overwritten by the new data from the current cycle.
If data from one circular log cycle exceeds the meter's
memory capacity, the earliest logged data will be lost.
[F1]
10.Press to accept the displayed Start Time or press
different start time. To start logging immediately, press
•
OK
If was selected, proceed to step 11.
•
NOW
If was selected, you have finished setting up the error log.
Proceed to Procedure Options on the next page.
•
EDIT
If was selected, complete the steps listed below.
[F1]-[F2]
a. Press to select
[ENT]
(1-12) and press
current time will generate an error message.)
b. Enter the desired Minutes and press
range is 0 to 59.
c. Enter the desired Seconds and press
range is 0 to 59.
[F1]
11. Press to accept the displayed Start Date or press
different start date. To start logging today, press
• OK TODAY
If or was selected, you have finished setting up the
error log. Proceed to Procedure Options on the next page.
•
Otherwise, continue with the next prompt to Edit the Start Date.
a. Enter the desired Year and press
0 to 99.
b. Use the [←], [→] and
Month.
c. Enter the desired Day and press
1 to the number of days in the selected month (28, 29, 30 or
31).
END TIME
is reached. A circular log runs
Caution!
AM PM
or . Then, enter the desired Hour
. (Entry of a start time earlier than the
[ENT]
. The acceptable
[ENT]
. The acceptable
[ENT]
. The acceptable range is
[F1]-[F4]
keys to select the desired
[ENT]
. The acceptable range is
March 2008
[F2]
to create a
[F2]
to enter a
[F3]
.
[F2]
to enter a
[F3]
.
3-11