Toro GREENSMASTER 3100 Operator's Manual page 19

PREPARING THE MACHINE FOR
MOWING
To help align the machine for successive cutting passes, do
the following to the No. 2 and No. 3 cutting-unit baskets:
1. Measure in approximately 12 cm from the outer edge
of each basket.
2. Either place a strip of white tape or paint a line onto
each basket paralleling the outer edge of each basket
(Fig. 13).
TRAINING PERIOD
Before mowing greens with the GREENSMASTER 3100,
we suggest that you find a clear area and practice starting
and stopping, raising and lowering the cutting units, turning,
etc. This will help you gain confidence in the performance
of the GREENSMASTER 3100.
IMPORTANT. If you shift to the No. 2 position while
cutting greens, no increase in speed will result. However,
a sudden Increase In speed will develop when you actu-
ate the lift pedal. For safety, use only the No. 1 position
for cutting greens and the No. 2 position for transport.
1. Fluid level (warm)
2. Warning buzzer
3. Float down, switch closed
1. Clean the rod or screwdriver
2. Warning buzzer
3. Press down on the switch float
2
1. Alignment strip
2. Approx. 12 cm
19
3
Figure 12
LEAK ALERT!
1
3
Figure 13
4
3
1
Figure 14
3. Cut grass on right
4. Keep focal spot 2–3 meters
ahead of the machine
1
2
2