Toro GREENSMASTER 3100 Operator's Manual page 15

circuit.
LEAK DETECTOR TEST/LIGHT SWITCH (Fig. 6)
From the middle operating position, move the switch rear-
ward to check the operation of the leak detector alarm and
time delay. Move the switch forward to operate optional
headlights.
HOUR METER (Fig. 6)—Shows the total hours of
machine operation. The hour meter starts whenever the key
switch is turned to ON.
SEAT ADJUSTING HANDLE (Fig. 6)—Located on the
left side of the seat, this lever allows four inch fore-and-aft
adjustment.
MOW LOCKOUT LEVER (Fig. 7)—locks the mow
pedal, preventing accidental starting of the cutting units. To
unlock, pull the mow lockout pin outward, rotate it clock-
wise and insert the end into the rear hole in the bracket.
SHIFT SELECTOR (Fig. 8)—Provides two traction selec-
tions, plus a NEUTRAL position. It is permissible to shift
from one selection to another while the machine is in
motion. No damage will result.
1. Neutral—Used for starting the engine.
2. No. 1 Position—Used for greens mowing operation.
3. No. 2 Position—Used for transport operation.
NOTE: If you operate the machine in reverse with the cut-
ting units down, they will be pulled off the lift arms.
STEERING ARM LOCKING LEVER (Fig. 8)—Rotate
the lever rearward to loosen, then raise or lower the steering
arm for comfort. Then rotate the lever forward to tighten.
To adjust the locking lever:
1. Rotate the lever rearward to loosen adjustment and
move the steering arm to its lowest position.
2. Loosen the lever set screw.
3. Rotate the adjusting bolt (left-hand thread) counter-
clockwise to tighten, or clockwise to loosen the adjust-
ment.
4. Tighten the set screw to lock the adjustment.
1. Mow lockout lever pin
3
1. Shift selector
2. Steering arm locking lever
3. Set screw
4. Adjusting bolt
15
Figure 7
1
2
4
Figure 8