Procedure Description Qty; No Parts Required - Toro 30506 Operator's Manual

Procedure
10
11
12
13
14
15
16
Media and Additional Parts
Description
Installation instructions
Certificate of compliance
1
Removing the Cutting Unit
from the Traction Unit

No Parts Required

Procedure
1. Position the machine on a level surface, raise
the cutting unit, engage the parking brake,
ensure that the traction pedal is in the neutral
position and the PTO lever in the O
shut off the engine, and remove the key from
the switch.
CAUTION
The counterbalance spring is in tension
when the deck is in the lower position
(200 Series traction units only).
Always raise the deck before adjusting
or removing the spring.
2. On 200 Series traction units only, disconnect the
counterbalance from the traction unit, remove
the lock pins from the brackets, separate the
Description
Bumper
Capscrew, 5/16 x 3 inch
Locknut, 5/16 inch
Trim molding
Deck cover
Belt guard
Pulley guard
Counterbalance spring
No parts required
Decal, danger
Chute assembly
position,
FF
Qty.
1
4
4
1
1
1
1
1
–
1
1
Qty.
1 Read before installation
1 CE certification
spring tension assemblies from the brackets,
and lay them down on the deck. Loosely secure
the lock pins to the brackets to prevent losing
them (Figure
1. Lock pin
2. Bracket
3. Lower the cutting unit and remove the 4 bolts
and nuts securing lift arm brackets to castor
arms (Figure
3
Use
Install bumper
Install the new deck cover.
Install the new safety guards.
Install the new counterbalance spring.
Install the cutting unit to the traction unit.
Install the new decal.
Mount the blower housing chute.
Use
1).
Figure 1
3. Spring tension assembly
2).
g012533