1. Bumper
3.
Using both mounting plates of the bumper as
templates, locate, mark, and drill 3 additional
11/32 inch diameter holes through both walls of
the front and rear castor arm brackets.
11
Installing the New Deck
Cover
Parts needed for this procedure:
1
Trim molding
1
Deck cover
Procedure
1.
Insert a trim molding onto the right bridge bar, so
the side of the spring bracket is 10 cm (4 inches)
to the far edge of the trim molding
1. Trim molding
2. Cover
2.
Hook the rear of the deck cover
the rear channel pin while aligning the cover
Figure 23
(Figure
Figure 24
3. Bolt
(Figure
mounting bolt with the hole in the right castor
arm. The cover is to rest on the trim molding.
Adjust the molding as required.
3.
Secure the cover to the right castor arm with
the bolt.
12
Installing the New Safety
g012551
Guards
Parts needed for this procedure:
1
Belt guard
1
Pulley guard
Procedure
1.
Install the belt guard onto the machine
25).
Note:
by removing it and using it to install the guard.
24).
1. Belt guard
2. Nut
g029097
2.
Install the pulley guard onto the machine
26).
24) onto
12
Use existing hardware on the machine
Figure 25
3. Bolt
(Figure
g029098
(Figure