Toro STX-26 Operator's Manual page 36

Adjusting the Traction-Control
Neutral Position
If the machine creeps forward or backward when
the traction control is in neutral and the machine is
warm, you may need to adjust the return-to-neutral
mechanism on the pumps; contact your Authorized
Service Dealer.
Adjusting the Traction-Control
Forward Position
If the machine does not drive straight when you hold
the traction control forward against the reference bar,
complete the following procedure:
1. Drive the machine with the traction control
against the reference bar, noting which direction
the machine veers.
2. Release the traction control.
3. If the machine veers to the left, loosen the right
jam nut and adjust the tracking set screw on the
front of the traction control
4. If the machine veers to the right, loosen the left
jam nut and adjust the tracking set screw on the
front of the traction control
Figure 52
1. Set screw
2. Jam nut
5. Repeat the procedure until the machine drives
straight in the full forward position.
Important:
Ensure that the set screws touch
the stops in the full forward position to avoid
overstroking the hydraulic pumps.
(Figure 52).
(Figure 52).
g004194
3. Stop
36