Reset (Reset System / Devices); Smart Access Point - ABB AccessControl System Manual

Table of Contents

3.5

RESET (Reset system / devices)

3.5.1

Completely resetting the "Smart Access Point".

–

Here all entered data, performed settings, etc., are deleted. After the reset the "Smart

Access Point" will be in the state at the point of delivery.

–

After the reset, an initial commissioning of the "Smart Access Point" must be carried out.

–

After the initial commissioning, old data can be read in via an available backup.

Fig. 47:

Completely resetting the "Smart Access Point"

Use the following steps for the reset:

1. Connect a PC with the "Smart Access Point".

–

More detailed information for connecting, see chapter 3.1.2 "Connecting a PC with the

"Smart Access Point "" on page 33.

2. Change to the "Settings" / "Service" function.

3. Call up the "Reset default settings" function.

4. Select the areas that are to be reset.

5. Confirm the selection.

–

The "Smart Access Point" is being reset.

–

After the reset the connection to the "Smart Access Point" is no longer active.

–

The "Smart Access Point" must be put back into operation via an initial commissioning,

see chapter 3.1 "Commissioning of the system - "Smart Access Point Pro"" on page 33.

System Manual 2CKA001473B5074

Commissioning

│60

Table of Contents