ABB AccessControl System Manual page 57

Table of Contents

3. Place the "RF Repeater" in building structure of the "Smart Access Point Pro".

–

To place the "RF Repeater", change into the management software of the "Smart

Access Point Pro".

–

For the necessary steps in the management software, see chapter 5.4.5 "Placing the

"RF Repeater"" on page 126

–

If the building structure is not available, first create it, see chapter 5.2 "Building

structure" on page 95

4. Coupling the "RF Repeater" in building structure of the "Smart Access Point Pro" with the

"Smart Access Point Pro", "RF/IP Gateway" or a "RF Repeater".

–

To couple, change into the management software of the "Smart Access Point Pro".

–

For the necessary steps in the management software, see chapter 5.4.6 "Coupling the

"RF Repeater"" on page 129

–

If the "Smart Access Point Pro", "RF/IP Gateway" or an additional "RF Repeater" is

not yet placed, carry this out first, see chapter 5.3 "Device configuration" on page

103 and see chapter 5.4 "Access control" on page 113

Notice

Depending on the installation, it can be practical to commission the "RF

Repeater" in advance together with the "Electronic cylindrical lock".

–

System Manual 2CKA001473B5074

For the advance commissioning, see chapter 5.5 "User management" on

page 131

Commissioning

│57

Table of Contents