2. Place the "RF/IP Gateway" in building structure of the "Smart Access Point Pro".
–
To place the "RF/IP Gateway", change into the management software of the "Smart
Access Point Pro".
–
For the necessary steps in the management software, see chapter 5.4.2 "Placing the
"RF/IP Gateway"" on page 117
–
If the building structure is not available, first create it, see chapter 5.2 "Building
structure" on page 95
Notice
Depending on the installation, it can be practical to commission the "RF/IP
Gateway" in advance together with the "Electronic cylindrical lock".
–
3.2.4
"RF Repeater"
The following points are a prerequisite for commissioning the "RF Repeater".
The power supply of the "RF Repeater" is established.
■
–
The power is supplied via a separate 24 V power supply.
The serial number of the "RF Repeater". This is located on the device.
■
A connection to the "Smart Access Point Pro". This must be the "Smart Access Point Pro"
■
that is used in the system.
"Smart Access Point Pro":
■
The "Smart Access Point Pro" must be ready for operation.
■
A PC is connected with the "Smart Access Point Pro".
■
The management software of the "Smart Access Point Pro" is opened on the PC.
■
Use the following points for commissioning the "RF Repeater":
1. Ensure that there is a radio connection between the "RF Repeater" and the "Smart Access
Point Pro". The radio connection can be implemented in different ways.
The "RF Repeater" is already mounted:
■
–
The communication is carried out directly with the "Smart Access Point Pro" or via
the already available installation of interconnected additional "RF Repeater".
–
If communication is not possible, the "RF Repeater" must be dismantled and put
near the "Electronic cylindrical lock". For additional information: see chapter 3.2.2
"Adding larger projects / devices in advance" on page 55.
The "RF Repeater" is not yet mounted:
■
–
The "RF Repeater" together with the required ancillary devices is brought into the
radio range of the "Smart Access Point Pro". For additional information: see chapter
3.2.2 "Adding larger projects / devices in advance" on page 55.
2. Add the "RF Repeater" in the "Smart Access Point Pro".
–
To add, change into the management software of the "Smart Access Point Pro".
–
For the necessary steps in the management software, see chapter 5.3.5 "Add "RF
Repeater"" on page 111
System Manual 2CKA001473B5074
For the advance commissioning, see chapter 3.2.2 "Adding larger projects /
devices in advance" on page 55
Commissioning
│56