Closing The Cover Plate Of An Rru Cabling Cavity - Huawei RRU3203-B12 Installation Manual

RRU3203
Installation Guide
Figure 8-19 Installing a CPRI fiber optic cable
Install the fiber optic cable in the cable clip near the power cable to leave some slack at the bend.
Tighten the screws on the cable clip to 1.4 N·m (12.39 lbf·in.).
Step 3 Connect the end labeled 2A and 2B of the fiber optic cable to the optical module on the BBU
side.
Step 4 Lay out the fiber optic cable by referring to
using cable ties.
Step 5 Label the fiber optic cable by referring to Attaching an L-Shaped Label.
----End

8.11 Closing the Cover Plate of an RRU Cabling Cavity

This section describes the procedure for closing the cover plate of an RRU cabling cavity.
Procedure
Step 1 Close clips and tighten the screws on each clip to 1.4 N·m (12.39 lbf·in.) using a torque
screwdriver, as shown in
Issue 06 (2012-04-16)
CAUTION
Figure
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8.1 Cabling Requirements, and then bind the cable
8-20.
8 Installing RRU Cables
81