Opening The Cover Plate Of An Rru Cabling Cavity - Huawei RRU3203-B12 Installation Manual

RRU3203
Installation Guide
----End

8.8 Opening the Cover Plate of an RRU Cabling Cavity

This section describes the procedure for opening the cover plate of an RRU cabling cavity.
Procedure
Step 1 Wear ESD gloves.
Take proper ESD protection measures, for example, wear ESD gloves, to prevent electrostatic
damage to the boards, modules, or electronic components.
Step 2 Loosen the six screws on the cover plate of the RRU cabling cavity using an M4 Phillips
screwdriver, and then open the cover plate, as shown in
Figure 8-14 Opening the cover plate of the RRU cabling cavity
Figure 8-15
Issue 06 (2012-04-16)
3. Lay out the cable by referring to
using cable ties.
4. Label the installed cable by referring to Attaching an L-Shaped Label.
CAUTION
shows the RRU cabling cavity.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8.1 Cabling Requirements, and then bind the cable
Figure 8-14.
8 Installing RRU Cables
76