Connecting Network Cable To The Colorpass; Back View Of The Colorpass - Canon Z5000 Configuration Manual

1
1-10 Connecting to the Network
!
10/100BaseT Ethernet (RJ-45)
Copier interface connector

Connecting network cable to the ColorPASS

In this section, the back panel of the ColorPASS is illustrated, followed by information
for connecting to the Ethernet board. For information about connecting to a Token
Ring network, see Appendix A, "Token Ring Network Option."
Shut down the ColorPASS before attaching it to any network device. If the ColorPASS
has just finished processing, wait 5 seconds after the system reaches the Idle state before
using the power switch to turn off the ColorPASS.

Back view of the ColorPASS