Canon Z5000 Configuration Manual page 147

6
6-5 Troubleshooting the ColorPASS
After this Setup screen:
Frame Type selection
(Network Setup>Protocol
Setup>IPX/SPX Setup)
Token Ring Setup
Enable NDS
(Network Setup> Service
Setup> PServer Setup > NDS
Setup)
Select NDS Tree
(Network Setup> Service
Setup>PServer Setup>
NDS Setup)
This message:
Invalid frame size.
Warning! IPX network
number is zero.
Can't detect Token Ring
hardware.
Token Ring hardware
not installed or
not functioning.
Can't autodetect the ring
speed. No device on ring.
No NDS trees found.
Warning! Selecting a new NDS
tree deletes Bindery setup.
Means:
The network hub is not connected to a Novell machine
when the ColorPASS tries to bind.
No other IPX machine can be found on the network, or
the network hub is not connected to the network, when
the ColorPASS tries to bind. When this occurs, the
network number defaults to zero.
ColorPASS queries the Token Ring hardware. Error
indicates that some components are not installed, are not
installed correctly, or not installed in the correct device. An
unsupported Token Ring board may be in use. Check with
your authorized service/support center.
The ColorPASS is trying to detect the current ring speed,
but it is the only machine on the Token Ring network.
Connect another machine to the Token Ring network first,
before connecting the ColorPASS.
No NDS trees were found on the Novell network. Check
to see that the frame types on the ColorPASS are properly
configured.
You have previously connected the ColorPASS to a
different NDS tree. NetWise supports only a single NDS
tree connection. To avoid a potential conflict with an
existing tree connection (for example, if the connection
was made through a NetWare 4.x server in emulation
mode), all bindery settings will be deleted.
If you choose OK, and choose Yes in the following message
screen ( Delete Bindery setup and continue? ), bindery
settings are deleted and have to be re-entered in Bindery
Setup.
To avoid deleting the bindery settings, press the Menu key,
or select OK and choose No in the following message
screen ( Delete Bindery setup and continue? ).
Repeat NDS Setup without changing the NDS tree, or exit
to Bindery Setup to review your current bindery settings.