Configuring The Colorpass And Clients For Fiery Webtools - Canon Z5000 Configuration Manual

5
5-16 Setting up Network Servers
• Print a Configuration page (see page 3-47).
Use the information on this page to determine the current ColorPASS settings.
• Load the TCP/IP network protocol (for Windows 95/98/Me/2000 only, also load Client
for Microsoft Networks) on the computer.
• Verify the Workgroup name of the computer in the Windows Network control panel.
Make sure the Workgroup name is the same as the one listed in ColorPASS Setup.
• For Windows 95/98/Me/2000 only, in the Windows Network control panel, configure
the computer to allow file sharing, and then restart the computer.
• Ping the ColorPASS (see page 5-20) to verify TCP/IP communication is successful.
Configuring the ColorPASS and clients for
Fiery WebTools
The Fiery WebTools provide access to many ColorPASS functions via the Internet (or
intranet), providing additional flexibility in remote management. You can access the
Fiery WebTools from a Windows computer.
T F W T
O SET UP IERY EB OOLS ON THE
1. In ColorPASS Network Setup, enable TCP/IP.
2. Set a valid, unique IP Address for the ColorPASS, and then set the subnet mask. Set a
gateway address if necessary.
3. Enable Web Services.
4. In ColorPASS Printer Setup, confirm the Print Queue is published.
C PASS:
OLOR