Table of Contents
Advertisement
6.2.2
Attaching the cabinet with the large-pole mounting kit
With the large-pole mounting kit, the front bracket blocks are clamped to the pole
with a metal band and locking device.
There are two types of band and locking device. One uses grooved metal bands,
as described in procedure [A] below. The other type of locking device uses
smooth bands and a locking rack, as described in procedure [B] below. Follow the
procedure for the type of locking device and band in your kit.
[A] Pre-assembling the pole brackets and bands (grooved band type)
1.
2.
Table 8.
Pole diameter
(mm)
140
160
180
200
220
240
260
280
300
DN991456
© Nokia Corporation
Issue 3 en
Nokia Proprietary and Confidential
All manuals and user guides at all-guides.com
Assemble the locking device and band by inserting the end of the metal
band approximately 25 mm (1 in.) into the locking device. The correct set
up of the parts is shown in Figure 12.
Bend the surplus end of the metal band underneath the locking device, as
shown in [3] [A] in Figure 12.
Flatten the bent-over end of the metal band to remove any distortion.
The locking device is now assembled.
Cut the metal band to the appropriate length, according to the pole
diameter. Refer to Table 8 below.
Band length for different pole diameters
Band length
(mm)
580
630
680
740
790
850
900
950
1010
Mounting the BTS
Pole diameter
Band length
(in)
(in)
5.5
22.8
6.3
24.8
7.1
26.8
7.9
29.1
8.7
31.1
9.5
33.5
10.2
35.4
11.0
37.4
11.8
39.8
41 (72)
Advertisement
Table of Contents
