Table of Contents
Advertisement
Removing a unit
1.
2.
3.
4.
Note
If the unit does not come out easily, rock it slightly from left to right using the
handle and then pull the unit out. Do not use excessive force!
Caution
When handling the units, beware of sharp edges!
26 (72)
© Nokia Corporation
Nokia Proprietary and Confidential
All manuals and user guides at all-guides.com
Lay the BTS on its back, in the position shown in Figure 4.
Loosen the upper and lower retaining screws of the unit to be removed
using a torque driver with a T10 Torx bit.
Loosen the screws enough to remove the unit, but leave them engaged in
the threads. By doing this, the screws remain in the optimal position for
reconnecting.
Slide the TRX units out of the slots by pulling from the handle on the front
panel of the TRX.
Remove the power supply unit, interface unit, and transmission unit by
pulling each unit out until it comes to a stop. Then lift the unit upwards and
outwards to remove it. See Figure 4.
Installation
DN991456
Issue 3 en
Advertisement
Table of Contents
