Lumberjack SCMS305DB Original Instructions Manual page 14

PREPARING FOR OPERATION
Setting the Trenching Facility
In its normally set position the trenching facility
(19) permits the blade to cut completely through
the workpiece, but when set the trenching
facility (19) allows the blade to cut only part way
through the workpiece.
– With the tool in the working position, pull the
trenching stop (32) towards the front of the tool.
– Adjust the depth screw (33) to the desired
length. Check height by pulling down blade as if
to cut workpiece.
– Tighten the depth lock (34) to lock the depth
screw into position.
Clamping the Workpiece
To ensure optimum working safety, the
workpiece must always be firmly clamped.
Do not saw workpieces that are too small to
clamp.
While clamping the workpiece, do not reach
under the clamping lever of either of the
clamps with your fingers.
– Press the workpiece firmly against the fence
(8).
SCMS305DB
– Insert the fast clamp (7) into one of the holes
intended for this purpose.
– Adapt the fast clamp to the workpiece by turning
the threaded rod.
– Tighten the main screwin order to clamp the
workpiece.
Adjusting the Cutting Angle
To ensure precise cuts, the basic adjustment of the
machine must be checked and adjusted as
necessary after intensive use.
Always tighten the locking knob (10) &
(18) firmly before sawing.
Otherwise the saw blade can become wedged in
the work piece.
Adjusting Standard Mitre Angles or Any
Angle
For quick and precise adjustment of commonly
used mitre angles, indentshave been provided for
on the saw table:
– Loosen the locking knob (10) in case it is
tightened.
– Rotate the saw table (13) left or right to the
requested indent.
– Tighten locking knob (10). As the table is turned
the indents will click as they are passed.
Use mitre gauge (11) to achieve desired angle.
12