Tool Operation - Positioning - Panasonic FP2-PP2T Technical Manual

2. Execute the home return. Click [Start] for the axis to execute the home return.
3. Click [Close] to close the dialog.
Note:
This dialog cannot be closed during the home return operation.

7.17.2 Tool Operation - Positioning

The test run is possible like actual positioning operations.
Specifying the starting table number enables to check if the positioning/interpolation from the starting
table operates properly.
Note:
For the positioning operation, the setting data should be downloaded to the positioning unit in advance.
The operations after the starting table number vary depending on the Operation patterns.
1. Click [Positioning] in the Tool operation dialog. The following dialog is shown.
7-34