Face The Monitors Inside - NEC CHIEF K3F220 Installation Manual

4. Adjust the horizontal position of the VESA plates and
arm angles to align the bottom edge of the upper
monitor with the top edge of the lower monitors
5. Tighten knobs to fix the position of the monitors.

Face the Monitors Inside

ImiouCoun:
always have spacers between all of the monitors before adjusting them to prevent the edges of the screens
from touching.
1. Follow the instructions for "Set the Vertical Arm
Position" on page 9 for the lower arms
2. Loosen hex screws
lower arms
3. Adjust the swivel angle between 0~15 degrees
towards the center Tighten the hex screws
4. Follow the instructions for "Attach the Monitors" on
page 10
5. Follow the instructions for "Set the Vertical Arm
Position" on page 9 to set a temporary position
upper arms
6. Repeat steps 2-4 of these instructions for the upper
monitors
7. Follow the instructions for "Installing the Upper Left and Upper Right Monitors" on page 13 to finalize the
position of the upper monitors
Ⓕ
for adjusting the swivel of the
Ⓕ
2 x 2 mUlti-monitoR installation (K3F220/K3g220) | 17
fully
CHIEF STAND INSTALLATION MANUAL | USER'S GUIDE
Ⓕ Ⓕ