Sony Airpeak S1 Help Manual page 61

Help Guide
Airpeak S1
ARS-S1
Linking the aircraft and remote controller
Follow the on-screen instructions in the "Airpeak Flight" App to link the remote controller and aircraft and set up the
aircraft. The aircraft only needs to be set up the first time.
Preparation
Confirm that the mobile device mounted on the remote controller is connected to the internet.
Charge the built-in remote controller battery sufficiently.
Charge both aircraft battery packs sufficiently.
On the remote controller, press and hold the
1
After startup, the status LED stops flashing and remains on.
On the aircraft, press and hold the
2
After startup, the power status LED stops flashing and remains on.
Start the "Airpeak Flight" App and follow the instructions on the screen to perform [Initial setup].
3
When the [Link remote controller to aircraft] screen is displayed in the "Airpeak Flight" App, tap [Start link].
4
The process of linking the remote controller and aircraft will start.
Within 2 minutes after performing step 4, press and hold the LINK button on the aircraft for 2 seconds.
5
Successful linkage is indicated by a remote controller blue status LED (in purple when linked as [Sub] in dual
operation mode) and the message [Aircraft and remote controller connected] on the "Airpeak Flight" App screen.
If linkage fails, check for obstacles between the aircraft and the remote controller. Move the aircraft and remote
controller to avoid obstacles and tap [Retry] to try again.
After the successful linkage screen displayed, tap [Start using] on the "Airpeak Flight" App screen.
6
The aircraft setup will start. When the message [Now the aircraft is ready to fly] is displayed, setup is complete.
To link the remote controller and aircraft by operating the remote controller
If you press and hold the C3 (Custom 3) button and
same time for at least 2 seconds, the linking process between the remote controller and aircraft will start in the same
manner as when performed from the "Airpeak Flight" App. Perform the above step 5 and subsequent steps within 2
minutes.
Related Topic
Charging the batteries
Selecting the wireless channel
Controlling the aircraft with two remote controllers (dual operation mode)
(Power) button for at least 2 seconds to turn on the power.
(Power) button for at least 2 seconds to turn on the power.
(Automated flight pause) button on the remote controller at the
61