Mitsubishi Electric MELSEC iQ-R Series Introduction Manual page 28

5.
Select the power line frequency.
6.
Set IPv4 to "Manual IP and manual DNS", and set network parameters.
IP address: 192.168.3.42
Ex.
7.
Turn off "Automatic date and time" and set the time manually.
• Set the IP address and subnet mask in the same segment as the IP addresses of the CPU and general-
purpose personal computer (Windows10).
• When the NTP server is in the same segment as the programmable controller, turn on "Automatic date and
time" and configure the time synchronization setting from the NTP server. In this case, the time setting FB is
not required.
• If the setting section for "Date and time" does not appear, set it after completing the initial start-up settings.
4 CAMERA RECORDING FUNCTION
27
4.1 Network Camera Setting