Network Camera Setting; Initial Start-Up Setting - Mitsubishi Electric MELSEC iQ-R Series Introduction Manual

4.1

Network Camera Setting

Use a web browser to configure the network camera setting. When the network camera is started up for the first time, network
settings such as the IP address setting are required. At the second and subsequent start-up, the camera can be accessed by
entering the password.

Initial start-up setting

Operating procedure
1.
Set the IP address of the personal computer for setting so that it is in the same segment as the IP address of the network
camera to be connected.
The IP address of the network camera can be checked on the network by using AXIS IP Utility.
AXIS IP Utility can be downloaded from the following URL.
www.axis.com/en
2.
Enter the IP address of the network camera in the web browser.
4 CAMERA RECORDING FUNCTION
25
4.1 Network Camera Setting