Installing Boards; Installing Idu Cables - Huawei OptiX RTN 950A Quick Installation Manual

Installing Boards

1
Loosen the screws on the filler panel and remove the filler panel.
Hold the ejector levers on the panel with hands and raise them to form an angle of approximately 45 degrees
between the ejector levers and the panel. Push the board gently along the guide rail until the board is secure.
Lower the two ejector levers of the board.
NOTE
Before installing and removing/inserting a board, wear an ESD wrist strap or ESD gloves. Before you insert a
board, ensure that the slot is correct. If it is difficult to insert the board, stop the operation.

Installing IDU Cables

1
Installing PGND Cables
When installing a PGND cable in the ETSI cabinet,
connect the PGND cable to the ground point on
the left side of the chassis.
2
Tighten the screws on the panel.
When installing a PGND cable in the 19-inch
cabinet, connect the PGND cable to the ground
point of the left mounting ear of the chassis.
22
3 4