Z: depth adjustment
Check the distance between the
furniture door and the housing unit. A
distance of approx. 2 mm is required.
Loosen the screws at the top of
the appliance door and the screw
on the bottom fixing bracket.
Tighten all screws again.
Fit the top covers and click them
into place.
Close the covers on the fixing
brackets.
To make sure the appliance is
correctly fitted:
– The doors must close properly.
– The door must not touch the housing
unit.
– The seal at the top edge of the
handle side must fit properly.
To double check, place a torch in the
appliance and close the door.
Switch the lights off in the room. If
you can see any light shining out from
the sides of the appliance, double
check the installation.
Installation
93