Miele KFNS 37432 iD Operating And Installation Instructions page 59

Message
The power symbol 
flashes in the display
and the warning tone
sounds.
The temperature display
will show the warmest
temperature recorded in
the freezer during a
power failure or an
interruption to the
power supply.
"F0 to F9" appears in
the display.
The following appears
in the display:
"FE*".
The  symbol lights up
in the display and the
appliance does not get
cold, although the
controls and the interior
lighting are working.
Possible cause and remedy
Indication of a power failure: The temperature in the
appliance over the last few days or hours has risen
too high because of a power cut or an interruption to
the power supply.
The appliance will go back to the last temperature
setting when the power is back on.
 Touch the OK sensor.
The display of the warmest temperature recorded in
the freezer will disappear. The display will then revert
to showing the current temperature in the freezer
section.
 Depending on the temperature displayed, you
should check whether food in the freezer has
started to thaw or has defrosted. Check that it is
still safe to use and, if so, use it as soon as
possible. Defrosted food may only be refrozen
after it has been cooked.
There is a fault.
 Call Miele.
There is a fault.
 Call Miele.
Demo mode is switched on. This allows the
appliance to be presented in Miele Experience
Centres and retail stores without switching on
refrigeration. Do not activate this setting for domestic
use.
 Switch off Demo mode (see "Information for Miele
Experience Centres and Chartered Agents - Demo
mode").
Problem solving guide
59