Table of Contents
Advertisement
6. To install a new hard disk drive into the bracket, flex the bracket and align pin
pin
4
on the bracket with the corresponding holes in the hard disk drive. Do not touch the circuit
board
5
on the bottom of the hard disk drive.
Figure 49. Installing the hard disk drive into the bracket
7. Slide the new hard disk drive into the drive cage until it snaps into position.
Figure 50. Installing the secondary hard disk drive
8. Connect the signal cable and the power cable to the new hard disk drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 87.
Solid-state drive
The solid-state drive is only available on some models. This section provides the following instructions:
•
"Installing the solid-state drive" on page 84
•
"Replacing the solid-state drive" on page 85
1
, pin
2
.
Chapter 7
Installing or replacing hardware
, pin
3
, and
83
Advertisement
Table of Contents
