Table of Contents
Advertisement
3. Insert a new slim optical drive into the enclosure until you hear a click. The slim optical drive is secured
in place.
Figure 33. Installing the slim optical drive in the enclosure
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 87.
Hard disk drive
Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page v.
To install or replace a hard disk drive in the optical/storage combination enclosure, do the following:
1. Slide the enclosure out of the chassis. See "Optical drive" on page 69.
2. Pinch the two clips toward each other as shown to open the rear cover of the enclosure.
Figure 34. Opening the enclosure from the rear
3. If you are replacing an old hard disk drive, do the following:
.
Chapter 7
Installing or replacing hardware
73
Advertisement
Table of Contents
