Table of Contents
Advertisement
6. Position the heat sink on the M.2 solid-state drive adapter. Ensure that the two mounting studs in the
heat sink are aligned with the holes in the M.2 solid-state drive adapter. Then, push the mounting studs
downward to secure the heat sink to the adapter.
Figure 22. Installing the heat sink
7. Install the M.2 solid-state drive adapter into the appropriate PCI Express card slot on the system
board. See "PCI card" on page 61.
Note: It is recommended that you install the M.2 solid-state drive adapter into the PCI Express x16 card
slot. See "Parts on the system board" on page 5.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 87.
Memory module
Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page v.
Your computer has four memory slots for installing or replacing DDR4 DIMMs that provide up to a maximum
of 128 GB system memory. When installing or replacing a memory module, use the following guidelines:
• Use any of DDR4 ECC UDIMMs or DDR4 ECC RDIMMs for your computer. Do not install the UDIMMs
and RDIMMs into the same computer.
• Use 8 GB ECC UDIMMs up to a maximum of 32 GB.
• Use 4 GB, 8 GB, 16 GB, or 32 GB ECC RDIMMs in any combination up to a maximum of 128 GB
system memory.
66
ThinkStation P410 User Guide
Advertisement
Table of Contents
