Table of Contents
Advertisement
6. Position the new memory module over the memory slot. Ensure that the notch
module is aligned with the key
the retaining clips completely close.
Figure 26. Installing a memory module
7. Reinstall the PCI Express x16 graphics card if you have removed it.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 87.
Optical drive
Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page v.
Note: For some computer models, the optical-drive bay might be installed with an optical drive, a 5.25-inch
flex module, a flex storage enclosure, or an optical/storage combination enclosure.
To install or replace an optical drive, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 57.
2. Remove the front bezel. See "Front bezel" on page 59.
3. If you are installing an optical drive, do the following:
a. Remove the metal static shield from the desired drive bay.
2
in the slot. Push the memory module straight down into the slot until
1
on the memory
.
Chapter 7
Installing or replacing hardware
69
Advertisement
Table of Contents
