Drive System Maintenance; Adjusting The Tracking - Toro 74412 Operator's Manual

Fuse:
• Main, F1-30 amp, blade-type
• Charge circuit, F2-25 amp, blade-type
• Optional head light kit, 10 amp, blade-type
1. Raise the seat to gain access to the fuse holder
(Figure 40).
2. To replace the fuses, pull out on the fuse to
remove it.
3. Install a new fuse (Figure 40).
Figure 40
1. Main, 30 amp
2. Charge circuit, 25 amp
3. For optional head light kit,
10 amp
4. Ignition switch
5. Throttle lever
Drive System
Maintenance

Adjusting the Tracking

Note: Determine the left and right sides of the
machine from the normal operating position.
The machine has a knob for adjusting the tracking
located under the seat.
Important: Adjust the handle neutral and
hydraulic pump neutral before adjusting
the tracking. Refer to Adjusting the Handle
Neutral in Controls System Maintenance,
page 39 and Adjusting the Hydraulic Pump
Neutral in Hydraulic System Maintenance,
page 40.
1. Push both control levers forward the same
distance.
2. Check if the machine pulls to one side. If it
does, stop the machine and set the parking
brake.
3. Unlatch the seat and tilt the seat forward to
access the tracking knob.
4. To make the machine go right, turn the knob
towards the rightside of the machine. Refer to
Figure 41.
5. To make the machine go left, turn the knob
towards the leftside of the machine. Refer to
Figure 41.
6. Repeat adjustment until the tracking is correct.
Figure 41
1. Pump rod
2. Turn this way to track left
34
3. Tracking knob
4. Turn this way to track right