Servicing The Fuses - Toro 74412 Operator's Manual

Figure 38
1. Battery
2. Terminal boot
3. Positive battery cable
4. Negative battery cable
5. Ground wire
6. Bolt (1/4 x 3/4 inch)
6. Remove both wing nuts (1/4 inch) securing
the battery clamp (Figure 38).
7. Remove the battery.
Installing the Battery
1. Position battery in the tray with the terminal
posts toward the engine (Figure 38).
2. First, install the positive (red) battery cable to
positive (+) battery terminal.
3. Then install the negative battery cable and
ground wire to the negative (-) battery terminal.
4. Secure the cables with 2 bolts (1/4 x 3/4 inch),
2 washers (1/4 inch), and 2 locknuts (1/4 inch)
(Figure 38).
5. Slide the red terminal boot onto the positive
(red) battery post.
6. Secure battery with J-bolts, hold down clamp
and 2 washers (1/4 inch), and 2 wing nuts (1/4
inch) (Figure 38).
7. Washer (1/4 inch)
8. Locknut (1/4 inch)
9. Battery clamp
10. J-bolts
11. Wingnut (1/4 inch)
Charging the Battery
Charging the battery produces gasses that
can explode.
Never smoke near the battery and keep
sparks and flames away from battery.
Important: Always keep the battery
fully charged (1.265 specific gravity). This
is especially important to prevent battery
damage when the temperature is below 32°F
(0°C).
1. Charge battery for 10 to 15 minutes at 25 to 30
amps or 30 minutes at 4-6 amps.
2. When the battery is fully charged, unplug
the charger from the electrical outlet, then
disconnect the charger leads from the battery
posts (Figure 39).
Figure 39
1. Positive Battery Post
2. Negative Battery Post
3. Install the battery in the machine and connect
the battery cables; refer to Installing the
Battery.
Note: Do not run the machine with the
battery disconnected, electrical damage may
occur.

Servicing the Fuses

The electrical system is protected by fuses. It
requires no maintenance, however, if a fuse blows
check component/circuit for malfunction or short.
33
3. Red (+) Charger Lead
4. Black (-) Charger Lead