Lenovo ThinkSystem SD530 Manual page 51

Network settings
Item
Network Interface Port
Shared NIC on
Fail-Over Rule
Burned-in MAC Address
Hostname
DHCP Control
IP Address
Subnet Mask
Default Gateway
IP6
Description
Options
Select the System Management Network Interface Port.
• Dedicated
Dedicated is the default setting.
• Shared
Note: This option is configuration dependent.
Select the shared NIC port.
1. ML2 Card
2. PHY Card
Note: This item is only on when network interface port is
on Shared, and this option is configuration dependent.
3. Onboard Port 1
Setting to control Fail-Over types allowed. None is the
• None
default setting.
• Failover to shared
(Optional Card
Note: This item is only on when network interface port is
ML2)
on Shared, and this option is configuration dependent.
• Failover to shared
(Optional Card
PHY)
• Failover to shared
(Onboard Port)
N/A
N/A Change the host name. The new name should be within 1
to 63 characters.
Configure DHCP Control or manually configure a static IP
• Static IP
address. Fallback will use static IP address if DHCP fails.
• DHCP Enabled
Select Static to enter IPV4 address manually. DHCP with
Fallback is the default setting.
• DHCP with
Fallback
x.x.x.x
Enter IP address in dotted-decimal notation.
When entering an invalid IP address:
• ERROR
• Invalid Input Range
• Ok
x.x.x.x
Enter Subnet Mask in dotted-decimal notation.
When entering an invalid IP address:
• ERROR
• Invalid Input Range
• Ok
x.x.x.x
Enter Default Gateway in dotted-decimal notation.
When entering an invalid IP address:
• ERROR
• Invalid Input Range
• Ok
Enable/Disable IPv6 support on management port.
• Enable
Enable is the default setting.
• Disable
.
Chapter 3 System configuration and boot management
47