Lenovo ThinkSystem SD530 Manual page 18

SP Redirection
Legacy OS/Option ROM
Display
COM1 Settings
COM1 Baud Rate
COM1 Data Bits
COM1 Parity
COM1 Stop Bits
COM1 Terminal Emulation
COM1 Active After Boot
COM1 Flow Control
COM2 Settings
14
ThinkSystem Server with Intel Xeon SP (1st, 2nd Gen) UEFI Manual
This option is only displayed while "Console Redirection",
• Enable
"COM Port 1" and "COM Port 2" set to [Enable]. It allows
• Disable
you to choose which COM port to have the redirection.
Note: Only show when set Console Redirection to
Enable.
Disable is the default setting.
Select a COM port to display redirection of Legacy OS
• COM Port 2
and Legacy OPROM Messages.
• COM Port 1
COM Port 1 is the default setting.
N/A Settings required for serial connections used for
asynchronous start-stop
Control the connection speed between the host and
• 115200
remote system. 115200 is the default setting.
• 57600
• 38400
• 19200
• 9600
Set the number of Data bits in each character.
• 8
• 7
Select parity bit in each character to be [None], [Odd], or
• None
[Even]. [None] means that no parity bit is sent at all. None
• Odd
is the default setting.
• Even
Set Stop Bits. Stop Bits sent at the end of every character
• 2
allow the signal receiver to detect the end of a character
• 1
and to resynchronize with the character stream.
Select [VT100] only if the remote emulator does not
• VT100
support ANSI text graphics. Consult the emulator
• VT-UTF8
documentation for more information. ANSI is the default
setting.
• ANSI
When [Disable] is selected, then Legacy Console
• Enable
Redirection is disabled before booting to legacy OS.
• Disable
When [Enable] is selected, then Legacy Console
Redirection is enabled for legacy OS. "COM1 Active after
Boot" and "COM2 Active after Boot" settings go together,
and if you change one setting, it automatically changes
the other. Disable is the default setting.
Select [Hardware] only if the remote emulator support and
• Disable
is using hardware flow control. Consult the emulator
• Hardware
documentation for more information. Disable is the
default setting.
N/A Settings required for serial connections used for
asynchronous start-stop
communication.
communication.