Lenovo ThinkSystem SD530 Manual page 50

Table 14. BMC settings settings
Item
Power Restore Policy
Ethernet over USB interface
Network Settings
Reset Factory Defaults Setting
Restart BMC
46
ThinkSystem Server with Intel Xeon SP (1st, 2nd Gen) UEFI Manual
Options Description
Determine the mode of operation after loss of power.
• Always Off
[Always Off]: System remains off upon power restore.
• Restore
[Restore]: System restores to the state it was before
power failed. [Always On]: System turns on upon power
• Always On
restore. Allow a few minutes for the changes to take
effect. Always Off is the default setting.
Note: This option is configuration dependent, and this
item could not use Setup load default to back to default
value.
[Enable] for using the xClarity Essentials in-band update
• Enable
utility. [Disable] will prevent xClarity Essentials and other
• Disable
applications that are running on the server from
requesting the BMC to perform tasks. Enable is the
default setting.
N/A Configure the network of the management controller.
N/A Restore all management controller settings to factory
defaults, including network configuration and credentials,
the management controller will be restarted automatically.
N/A Restart the BMC.